Advertisement
7.Attachthe Reflectoronto EmitterGrid by
using4 of the 1/4" SpringWashersand 1/4"
Wing Nutsprovided. S ee Fig. 4.
8. Slidethe Tank Coverthroughthe LowerPost
and onto the WeightedBase.See Fig.
5.
9. Lift the assembled
Upper Post and insert the
balance of the Fuel Hose through
Lower Post.
10. Keep the Upper Post slightly
lifted and turn it
until its screw hole faces the same direction
as the sliding channel
of the Lower Post.
Slide Upper Post into Lower Post, until the
holes on both posts align. Tighten securely
using 1 of the T4x15 Self-Tapping
Screws
provided.
11. Raise the Tank Cover and tilt it sideways until
it rests onto the bracket of the Lower Post.
Connect the hose end fitting of the Regulator
Assembly
to the stainless
steel Fuel Hose.
Tighten securely with two adjustable
wrenches.
12. Carefully
bend the stainless steel Fuel Hose
at a 90 degree angle. Hold the connected
hose fittings against the installed
Hose Holder
A, and secure Hose Holder B to Hose Holder
A by inserting the Fastening
Strip into the
slot of Hose Holder A.
Tighten firmly
using
the 3/16"xl/2"
Phillips
Head Screw, and the
3/16" Spring Washer and 3/16" Nut provided.
Use adjustable
wrench to tighten the Nut.
Figure
4
EMITTER
Figure
5
SLIDING
CHANNEL
TANK
COVER
I
STAINLESS
FUEL
HOSE
UPPER
POST
f"
LOWER
POST
jJ
BRACKET
HOSE
HOLDER
B
FASTENING
STRIP
BELOW
REGULATOR
ASSEMBLY
HOSE HOLDER
A
(previouslyinstalled)
SLOT
FOR
FASTENING
STRIP
11
Advertisement
