Self Cleaning
Self-Clean
Cycle Time Length
Flex
Delay
The cleo_pad controls the Self-Cleaning
feature.
When
used with a the Start pad,
a delayed
Self-Cleaning
cycle may also be programmed.
The Flex Clean feature
allows for any Self-Cleaning
cycle time from 2 (2:00) to 4 hours (4:00).
You may
also choose the clean time in 1 minute increments
(for example
2 hours and 50
minutes) by pressing the number keypads 2 50.
If you
are
planning
to use the oven
directly
after
a self-clean
cycle
remember
to
allow
time
for
the oven
to cool
down
and
the oven
door
to unlock.
This norma!ly
takes
about
one hour. So a 3 hour
self-clean
cycle
will
actually
take
about
4 hours
to complete.
_lt is recommend
to use a 2 hour
self-clean
cycle
for
light
soils,
a 3 hour
cycle
for
average
solls,
and
a 4 hour cycle
for heavy
solls
(to assure
satisfactory
results).
To avoid
possible
burns
use care when opening
the oven door
after the Self-Cleaning
cycle. Stand
to the side of the oven when opening
the door to allow
hot air or steam to
escape.
DO NOT force the
oven door open. This can damage
the automatic
door locking
system.
Use caution and avoid possible
burns
when opening
the door after the Self-
Cleaning
cycle has completed.
The
oven may still be VERY HOT.
INSTRUCTIONS
PRESS
DISPLAY
To start an immediate
Self-Cleanlng
cycle or to set a Delay
Start
time
of 9:00
o_clock and shut-off
automatically
(e×ample
provided
is a default
3 hour
Self-CJean
cycle)
1.
Be sure the clock is set with the correct
time of day, the oven is
EMPTY and the oven door is closed.
Fbx
2.
Press cl.... "CLEAN"
will flash and "3:00"
HR will show in the
display
(Fig. 1). The control will automatically
clean for a 3 hour
period
(default
self-cleaning
cycle time). Note: If a 2 or 4 hour
clean time is desired,
press 2 0 0 for 2 hour or press 4 0 0 for a
4 hour clean time. Set the cleaning
time based on the amount
of
soil: light, medium
or heavy (_ See above).
3.
Press _.
The "DOOR LOCKED"
icon will flash (Fig. 2).
4.
The motor
driven oven door loci< will begin to close automatically.
Once the door has been locked the "DOOR
LOCKi_D"
indicator
light will stop flashing
and remain
on (Fig. 3).
Note: Allow about 15 seconds for the oven door loci< to close.
Note:
If the optlonal
delay
Self-Clean
feature
is needed,
finish
steps
5-7. If Self-Clean
is started
immediately
sklp the remaining
steps and
continue
with
"When
the Self-Clean
cycle
is done"
on the following
page.
Delay
5. Press Start (Fig. 4). Enter the desired
Self-Clean
starting
time using
the number pads 9 0 0 (Fig. 5).
6.
Press _T_. "DELAY", "DOOR
LOCKED",
"CLEAN"
and Cooktop
locked icons will remain on.
7.
The control
will calculate
forward
from the set start time to
determine
when the Self-Cleaning
cycle should end. The Self-
Cleaning
cycle will turn on automatically
at the set time. At that
time the icon "DELAY" will go out; the oven icon wiii come on, the
start time, ';CLEAN" and "CLn" will remain
in the display
(Fig. 6)
Flex
Clean
2000r400
©
Delay
Start
900
@
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
28