Sony STR-DN840 Operating Instructions Manual page 37

7
b
Press .
"Connecting to the Internet" appears
on the TV screen. "Network setup is
completed" appears after the network
settings are completed. To return to the
Network Settings menu, press
(Depending on the network
environment, the network settings may
take some time.)
8
Perform the server settings.
To listen to audio content stored on the
server, you need to set up your server
(page 57).
Tip
When checking the network settings, see
"Information" (page 95).
Using a wireless LAN
connection
There are several connecting methods you
can use to set up a wireless network:
searching for an access point, using a WPS
connecting method (either the push-button
method or the PIN code method), or
manual setting.
Notes
• Make sure not to use the wireless LAN function
where medical equipment (such as a pacemaker)
is used or where the use of wireless
communication is prohibited.
• Before connecting to your home network, you
need to prepare a wireless LAN router/access
point. For details, refer to the operating
instructions of the device.
• Depending on your home network environment,
the wireless LAN router/access point may have
been set up such that it cannot be connected
using WPS, even though it is compatible with
WPS. For details on whether your wireless LAN
router/access point is compatible or not
compatible with WPS, and on the setup of a
WPS connection, refer to the operating
instructions of your wireless LAN router/access
point.
• You may encounter setup difficulties if the
receiver and the wireless LAN router/access
point are located too far from each other. If you
do, move the devices closer to each other.
Searching for an access
point and setting up a
wireless network (Access
Point Scan method)
You can set up a wireless network by
.
searching for an access point. To set up the
network using this connection method, you
will be required to select or enter the
following information. Check the
following information in advance, and
record it in the space provided below.
The network name (SSID
identifies your network
will be needed in step 7.)
:
If your wireless home network is
secured by encryption, the
security key (WEP key, WPA/
WPA2 key) for your network
(This will be needed in step 8.)
:
* SSID (Service Set Identifier) is a name that
identifies a particular access point.
** This information should be available from a
label on your wireless LAN router/access
point, from the operating instructions, from
the person who set up your wireless network,
or from the information provided by your
Internet service provider.
1
Select "Wireless Setup" in step 5
in "Using a wired LAN connection"
(page 36).
If "Change Settings?" appears on the
TV screen, select "OK", then press
.
2
Press V/v repeatedly to select
"Access Point Scan", then press
.
The receiver starts searching for access
points, and displays a list of up to 30
available network name (SSID).
3
Press V/v repeatedly to select the
network name (SSID) you want,
then press
The security setting display appears on
the TV screen.
*
) that
**
. (This
**
.
.
37
US