Cleaning Instructions - Pride Mobility Jazzy 1103 Ultra Owner's Manual

V I I I .
Monthly Checks
n Check that the anti-tip wheels do not rub the ground when you operate the power chair. Adjust them as necessary. See
V. “Comfort Adjustments.”
n Check for extreme wear on the anti-tip wheels. Replace them as necessary.
n Check for drive tire wear. See your authorized Pride Provider for repair.
n Check the caster wheels for wear. Replace them as necessary.
n Check the caster forks for damage or fluttering which indicates that they may need to be adjusted or have the bearings
replaced. See your authorized Pride Provider for repair.
n Keep your power chair clean and free of foreign material, such as mud, dirt, hair, food, drink, etc.
Yearly Checks
Take your power chair to your authorized Pride Provider for yearly maintenance. This helps ensure that your power chair
is functioning properly and helps prevent future complications.
Storage
Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries
from the power chair. See VI. “Batteries and Charging.”
WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be
damaged.

Cleaning Instructions

WARNING! Never hose off your power chair or place it in direct contact with water. Your power chair
has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
Tire/Wheel Replacement
If you have pneumatic tires and you have a flat tire, you can
replace the tube. If your chair is equipped with a solid tire
insert, then you must replace the whole wheel assembly.
Replacement tires, tubes, and wheel assemblies are readily
available through your authorized Pride Provider.
WARNING! To avoid possible injury, be sure
that the controller’s power is turned off and
the power chair is not in freewheel mode
before performing this procedure.
WARNING! Completely deflate the tire
before attempting repair.
Follow these easy steps for a quick and safe repair
for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate it before removing the wheel.
4. Remove the drive wheel nut from the wheel hub. See figure 31.
42
C A R E A N D
www.pridemobility.com
M A I N T E N A N C E
WHEEL HUB
REAR RIM HALF
FRONT RIM HALF
WASHERS
SCREWS
Figure 28. Jazzy 1103 Ultra Drive Wheel
Jazzy 1103 Ultra/RevB/Feb04
TIRE