Controller Position - Pride Mobility Jazzy 1103 Ultra Owner's Manual

V . C O M F O R T
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
Note: If the lever will not rotate to the
fully closed position, then turn the nut
counterclockwise one quarter or one
half turn.
Foot Platform Angle
You can adjust the angle of the foot platform with a hex key.
See figure 17.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the setscrew counterclockwise to raise the front of
the foot platform.
3. Turn the setscrew clockwise to lower the front of the
foot platform.

Controller Position

You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn the rear shroud fasteners one quarter turn. See
figure 6.
2. Remove the rear shroud.
3. Unplug the motor connectors, the charger inhibit, and
the battery connector from the power pod. See figure 7.
4. Cut the wire tie(s) that attaches the controller cable to
the armrest.
5. Flip up the armrest and loosen the setscrew. See figure 18.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Use a wire tie to secure the controller cable to the armrest.
11. Plug the motor connectors, the charger inhibit, and the
battery connector into the power pod. See figure 7.
12. Reinstall the rear shroud and tighten the fasteners.
24
A D J U S T M E N T S
SETSCREW
FOOTREST
EXTENSION
www.pridemobility.com
SETSCREW
Figure 17. Bottom View of Footrest
Figure 18. Underside of Armrest
SFR RELEASE LEVER
Figure 19. Swing-Away Footrests
Jazzy 1103 Ultra/RevB/Feb04
FOOTREST
ADJUSTMENT
SCREWS