Troubleshooting - Sunbeam Turbo Steam Instruction Manual

IRONING PANTS
• Begin with the waistband and inseam area, then pockets and cuffs.
• Pull waistband on pointy end of the board, as if you're "dressing" the ironing board. Iron upper-front part of the pants,
including the waistband.
• Place pants parallel to ironing board lengthwise so both legs are facing the same direction. Iron each leg by moving
the iron back and forth along the pant leg.
• Take cuff of the leg and bring it over towards the waistband to iron the inner part of the leg. Repeat these 2 steps for
the second leg.
PROBLEM
"Power" indicator light is blinking and
fabric setting light is off
Iron is not heating
Iron will not steam
Iron is leaking
Iron leaves spots/flakes on clothing
Wrinkles are not sufficiently removed
Fabrics are getting an unwanted "shine"
I t
ronIng
Trouble Shooting
CAUSE/SOLUTION
• The red light blinks and beeps 6 times to indicate that the iron auto-
off function has been activated.
• To stop blinking and reset, move the iron back and forth and allow to
re-heat until the indicator light turns solid blue.
• Ensure the iron is on and the light below fabric setting is illuminated.
• Verify unit is plugged in.
• Adjust fabric selection to the correct setting for your garments.
• Ensure water tank level is at least ¼ full.
• Ensure steam lever is switched on.
• Press Shot of Steam
• Only fill with water to the MAX level.
• Allow to heat for at least 2 minutes before use, and wait until the
indicator light "Ready" has turned solid blue to indicate that it is
ready.
• Shot of Steam
shot of steam
• Steam Setting and/or Shot of Steam
setting. Only use with Wool, Cotton or Linen fabric settings.
• Empty water tank after each use and turn steam lever off.
• Empty water tank completely after each use.
• Clean soleplate when cool with a wet, damp cloth.
• Use self-cleaning feature once a month.
• Refer to the Anti-Calcium System section.
• Ensure water cup used to fill the iron is clean.
• Check that the iron is set to the correct fabric setting.
• Use Shot of Steam
stubborn wrinkles.
• Use an ironing cloth or a 100% white cotton fabric and place it between
the garment being ironed and the iron to prevent "shine".
(continued)
Ips
® button several times to prime.
® button has been pressed too frequently. Only use
® button in 3 second intervals or less.
® or Spray Mist
® button used with incorrect fabric
TM features to help remove