Advertisement
IRONING PANTS
• Begin with the waistband and inseam area, then pockets and cuffs.
• Pull waistband on pointy end of the board, as if you're "dressing" the ironing board. Iron upper-front part of the pants,
including the waistband.
• Place pants parallel to ironing board lengthwise so both legs are facing the same direction. Iron each leg by moving the
iron back and forth along the pant leg.
• Take cuff of the leg and bring it over towards the waistband to iron the inner part of the leg. Repeat these 2 steps for
the second leg.
PROBLEM
Power indicator is blinking
Iron is not heating
Iron will not steam
Iron is leaking
Iron leaves spots/flakes on clothing
Wrinkles are not sufficiently removed
Fabrics are getting an unwanted "shine"
I
t
ronIng
IpS
Trouble Shooting
CAUSE/SOLUTION
• The light blinks to indicate that the iron auto-off function has been
activated.
• Press it to restart.
• To stop blinking and reset, move the iron back and forth and allow to
re-heat for 2 minutes.
• Ensure the iron is on and power light is illuminated.
• Verify unit is plugged in.
• Adjust Fabric Select Setting to the correct setting for your garments.
• Ensure water tank level is at least ¼ full.
• Ensure steam lever is switched on.
• Press Shot of Steam
• Only fill with water to the MAX level.
• Allow to heat for at least 2 minutes before use.
• Shot of Steam
steam
in 3 second intervals or less.
®
• Shot of Steam
Wool, Cotton or Linen settings.
• Empty water tank after each use and turn steam lever off.
• Empty water tank completely after each use.
• Clean soleplate when cool with a wet, damp cloth.
• Use self-cleaning feature once a month.
• Refer to the Anti-Calcium System section. (select models only)
• Ensure water cup used to fill the iron is clean.
• Check that the temperature select is set to the correct fabric setting.
• Use Shot of Steam
stubborn wrinkles.
• Use an ironing cloth or a 100% white cotton fabric and place it between
the garment being ironed and the iron to prevent "shine".
(continued)
button several times to prime.
®
has been pressed too frequently. Only use shot of
®
feature used with incorrect fabric setting. Only use with
®
or Spray Mist
features to help remove
®
TM
Advertisement
