Kenmore 415.162090 Use And Care Manual page 20

CAUTION
• Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety reasons.
• Do not use water on a grease fire. Personal injury may
result. If a grease fire develops, turn knobs and LP tank
off.
• Do not leave grill unattended while preheating or
burning off food residue on high. If grill has not been
regularly cleaned, a grease fire can occur that may
damage the product. Follow instructions on General
Grill Cleaning and Cleaning The Burner Assembly to
prevent grease fires.
Ignitor Lighting
s
Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP tank.
2. Turn left knob to preheat to light.
3. Push ignitor button rapidly (up to 5 times) to light. Be sure
burner lights and stays lit.
4. If burner does not light, turn knobs t
again.
5. Once left burner is lit, turn right knob to
6. If ignitor does not work, wait 5 minutes, then follow match
lighting instructions.
After Lighting : Turn knobs to
not warm up grill with knobs in
handle will become uncomfortably hot if left in preheat
position.
CAUTION
If burner does not light, turn knobs to OFF, wait 5
minutes, and try again. Always close valve during the 5
minute waiting period. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidentally ignite with risk of injury.
20 • 463350505
o OFF , wait 5 minutes, try
preheat to light.
HIGH position for warm-up. Do
preheat position. Knobs and
Match-Lighting
s Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP tank.
2. Match holder is on the right rear leg. Attach match to match
holder, light match. Place match into match lighting hole from
outside of grill bottom (as shown).
3. Push in and turn right knob to preheat position. Be sure
burner lights and stays lit.
4. Light left burner by pushing left knob in and turning to
preheat position.
Hose Check
• Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Normal
Hose
Before Your First Cookout
• Light burners, check to make sure they are lit, close the lid and
warm up grill on HIGH for 15 minutes. This curing of paint and
parts will produce an odor only on first lighting.
Burner Flame Check
• Light burner, rotate knobs from HI to LO. You should see a
smaller flame in LO position than seen on HI. Always check
flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the
Match lighting hole
Kinked
Hose
Troubleshooting Section .
HI
LO