Front And Rear Panel; Control Panel - Yamaha EMX 5000-20 Owner's Manual

10

Front and rear panel

Front and rear panel

Control panel

Channel control section
In this section, you can adjust equalization (fre-
quency response), volume level, effect and AUX
output levels for the input signal of each channel.
1
*
2
3
4
5
6
7
9
0
A
B
C
EMX5000-20/EMX5000-12—Owner's Manual
1
26 dB pad switch
This switch attenuates the input signal by 26 dB.
Attenuation is on when the switch is pressed
inward.
2
GAIN control
Use this knob to adjust the sensitivity according
to the input signal level, so that the input level is
2
appropriate.
For the best balance of S/N ratio and dynamic
range, adjust this knob so that the peak indicator
0 lights occasionally.
* When the knob is at the " " position, the input
sensitivity will be +4 dB.
4
3
(High pass filter) switch
This is an on/off switch for the high-pass filter.
The high-pass filter is on when the switch is
pressed inward, and the frequency region below
80 Hz will be attenuated at 18 dB/octave.
4
Equalizer controls (HIGH, MID, LOW)
5
This is a 3-band equalizer that adjusts the high
frequency range, mid frequency range, and low
frequency range of each channel.
When the HIGH and LOW knobs are in the " "
position, the high and low ranges will have a flat
6
response. Turning a knob toward the right will
boost the corresponding frequency range, and
turning it toward the left will cut it.
8
For the mid range, use the upper MID knob to
specify the center frequency of the range, and use
9
the lower knob to set the amount of boost or cut
that will occur. The frequency response is flat
0
when the lower knob is set to the " " position.
A
Turning the lower knob toward the right will
boost the corresponding frequency range, and
B
turning the knob toward the left will cut it.
The base frequency (or center frequency), range
of boost or cut, and equalizer type of each band
are as follows:
HIGH: 10kHz, ±15 dB,
MID:
LOW: 100Hz, ±15 dB,
C
shelving type
250Hz–5kHz, ±15 dB, peaking type
shelving type