BRIEF OPERATING
INSTRUCTIONS
FIG. 2. REAR PANEL
REAR
PANEL
eeoesoeme
CITI
TTT
ТАМА
татар MKE EM
SERIES
PHONE
JACK
TAKES
PRIORITY
TAPE
"oe
OEM
SPEAKERS
LINE шт
AUK IN
120¥
OW
БОН
ыу ia ie LTD
©
ZN
NN
Ke?
у
1
3
8:
Жа
P
:
{
EEE
ат
|
T
US and Canadian
Models
Q POWER CORD
This 3-wire cord is for connection
to any 120 volts AC, 50 or 60 Hz grounded outlet of US &
Canadian models, and to any one of 110, 130, 220 and 240 volts AC, 50/60 Hz of General model.
@ SPEAKER OUTPUTS 1 &2
There are two sets of parallel-wired speaker outputs (#1 and #2), each of which has a 1/4" (6.3mm)
tip/sleeve phone jack and a pair of push-terminals.
If a phone jack is used, the associated
push
terminals are automatically disconnected from the amplifier. The minimum overall load impedance
is 4 ohms.
When a single 4 ohms speaker is connected to either the #1 or #2 output, the amplifier will deliver
up to 100 watts continuous average (RMS) power. When a single 8 ohms speaker is connected to
either the #1 or #2 output, the amplifier will deliver up to 65 watts continuous power. If using a
pair of 8 or 16 ohms speakers, connect one each to the #1 and #2 outputs. We recommend using 18
gauge "zip cord" or even heavier wire; strip 1/3'' of insulation, twist the strands, press in the tab on
the speaker output terminal, insert the bared wire in the center hole, and release the tab.
|
CAUTIONS
1. Do not connect more than one 4 ohms speaker to the mixer since the amplifi-
er will be overloaded.
2. Never plug the speaker output into anything but a speaker load or a direct
box made for high power levels, and never patch an output directly back t to an
input unless directed to do so by this manual.