Rear Panel - Yamaha DM3 Owner's Manual

Rear Panel

a
c
a [OMNI OUT] Jacks
Has XLR-3-32 type output jacks for outputting analog
audio signals. These jacks are primarily for outputting
MIX channels and STEREO channels.
b [INPUT] Jacks
For connecting to mikes and musical instruments.
1 to 12: XLR-3-31 type input jacks
13 to 16: Combo jacks compatible with both XLR-type
and TRS phone plugs.
c Power Switch
In position ( l ), the power switch is ON.
In position (z), the power switch is on standby.
NOTICE
• The power switch goes to standby at least 10
seconds after the last operation. The product saves
the state immediately before going into standby, and
reproduces it when the power is back on.
• Let at least 6 seconds elapse after the power switch
goes into standby before turning it back ON.
Constantly turning the power switch ON/OFF may
result in malfunction.
d [DC INPUT] Connector
For connecting to the included power adaptor. First
connect the product to the power adaptor and then
insert the power plug into the outlet.
Only ever use the included cord as the power cord.
Also, never use the included power cord for another
product. Doing so may result in failure, overheating
and/or fire.
d
WARNING
e f g
• Always put the power switch on standby before
connecting or disconnecting the power cord.
• A small amount of power flows even when the
power is OFF (on standby). When the product will
not be used for a long time, always unplug the
power cord from the outlet.
e Dante PRIMARY/SECONDARY Connectors (DM3
only)
These connectors are for Dante audio network
connections, such as for I/O devices like the Tio1608-D.
Use RJ-45 connectors that are compatible with Neutrik
etherCON CAT5e.
NOTICE
To prevent electromagnetic interference, use an STP
(Shielded Twisted Pair) cable. Make sure that the
metal parts of the plugs are electrically connected to
the STP cable shield by conductive tape or
comparable means.
NOTE
Do not use a network switching EEE function (*) within
the Dante network.
The interactive power saving settings between switches
compatible with the EEE function are adjusted
automatically, but the interactive setting fails to adjust
properly with some switches.
As a result, the EEE function may be enabled in
inappropriate points in the Dante network, which can
lead to poor clock synchronization and choppy audio.
So pay attention to the following points.
• If using a managed switch, turn OFF the EEE function
of all ports that use Dante. Do not use switches
whose EEE function cannot be turned OFF.
• Do not use switches compatible with the EEE function
when using a managed switch. The EEE function of
these switches cannot be turned OFF.
b
CAUTION
DM3 Owner's Manual
11