Storage; Troubleshooting - Gastroback Design Espresso Advanced Barista Edition Operating Instructions Manual

cleAning THe Drip TrAY
The drip tray should be removed, emptied and cleaned at regular intervals, particularly when
the drip tray full indicator is showing ›Empty Me!‹.
Remove grid, compartments and ›Empty Me!‹ indicator from the drip
tray. Dispose of the grounds from the dry compartment into the waste
bin. Wash the drip tray with warm soapy water, using a non-abrasive
washing liquid, rinse and dry thoroughly. The ›Empty Me!‹ indicator can
be removed from the drip tray by pulling upwards to release the side
latches. The drip tray base and cover are dishwasher safe.
cleAning THe sTorAge TrAY
The storage tray can be removed after the drip tray is removed then cleaned with a soft,
damp cloth (do not use abrasive cleansers, pads or cloths which can scratch the surface).

sTorAge

Before storing, press the POWER-button to off, turn the steam dial to off
and unplug. Remove unused beans from the hopper, empty the water
tank and the drip tray. Ensure the machine is cool, clean and dry. Insert
all accessories into position or into the storage tray. Store upright. Do
not place anything on top.
wArning:
Do not immerse power cord, power plug or aplliancein water or any other
liquid. Tthe water tank should never be removed or completely emptied during decalcifying.
TrouBle sHooTing guiDe
PROBLEM
When the machine is switched
on, the steam and hot water
lights are flashing.
Espresso does not run through.
Espresso runs out too quickly
POSSIBLE CAUSES
Steam dial is not in STAND BY-position
Machine is not turned on or plugged in
Water tank is empty
Espresso grind is too fine
Too much ground espresso in the filter
Espresso grind tamped too firmly
The filter is blocked
The espresso grind is too coarse
Not enough ground espresso in the filter
Ground espresso not tamped firmly enough Refer to ›Tamping The Ground Espresso‹, page 55.
WHAT TO DO
Turn the Steam dial to STAND BY-position. Machine
will commence normal heat up procedure.
Ensure the machine is plugged in and the POWER
button is pressed to on.
Refer to ›Filling The Water Tank‹, page 53.
Ensure you use a suitable espresso grind. Refer to
›Adjusting the Grind Size‹ on page 54.
Refer to ›Adjusting the Grind Amount‹, page54.
Refer to ›Tamping The Ground Espresso‹, page 55.
Clean the filters. Refer to ›Cleaning The Filters‹,
page 65.
Ensure you use a suitable espresso grind. Refer to
›Adjusting the Grind Size‹ on page 54.
Refer to ›Adjusting the Grind Amount‹, page54.
66