Canceling A Cycle; Changing A Cycle Or Setting - Kenmore ULTRA WASH 665.15832 Use And Care Manual

Use this cycle for china Use
and crystal. This cycle covered
uses a light wash and detergent
gentle dry. During the dispenser
heated dry, the heating section.
element cycles on and off.
Initial display time: 68 min
Soil Wash Rinse Main Rinse Final Dry Cycle Water
Level Wash or Heated Time Usage
Sensed Purge Rinse (rain) (gal/L}
• • • • • 72* 8.6/32.7
Heavy 130°F cycled
(s4oc)
• • • • 58* 4.8/18.2
Light 130°F cycled
(s4oc)
Use this cycle for pre- Use
rinsed or lightly-soiled covered
loads. The sensor adds detergent
water and time, if needed, dispenser
for maximum cleaning, section.
No drying options are
available for this cycle.
Initial display time: 26 min
Soil Wash Rinse Main Purge Final Dry Cycle Water
Level Wash Heated Time Usage
Sensed Rinse (rain) (gaUL)
• • • • 30* s.g/26.t
Heavy 140°F
(eooc)
• • • 26" €.8,'18.2
Light
140°F
(6o°c)
Use this rinse cycle for Do not use
rinsing dishes, glasses, detergent
and silverware that will with this
not be washed right away, cycle.
Initial display time: 10 min
Soil Wash Rinse Main Rinse Final Dry Cycle Water
Level Wash Heated Time Usage
Sensed Rinse (min) (gaUL)
• • 14 4.3/16.4
Heavy
• 10 2.2/8.2
Light
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
Canceling a Cycle
Anytime during a cycle, press
The dishwasher pauses for about 5 seconds. Then the
display shows
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
NOTE: A small amount of water remains in the dishwasher. This
is normal.
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear all
options and cycles.
Changing a Cycle or Setting
During the first fill of a cycle
1. Press a new cycle and/or options.
2, Check the detergent dispensers. They must be filled properly
for the new cycle.
After the first fill of a cycle
1. Press
The display shows
2,
3,
4.
5.
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
Check the detergent dispensers. They must be filled properly
for the new cycle.
Close the door.
Press a new cycle and/or options.
Press START.
14