Victory Vegas 2008 Owner's Manual page 103

MAINTENANCE
Rear Wheel
Alignment
NOTE: Turn the axle adjusters about 1/16 of a turn at a time and
monitor wheel alignment as you proceed.
5. On screw style adjusters: Use a 17mm wrench to loosen lock nut
(4), then an 8mm hexagonal wrench to turn the axle adjuster
screws (5).
On nut style adjusters: Use a deep 14mm socket to turn the
adjuster nut (6).
6. On both styles: Turn the screw or nut IN (clockwise) to draw the
axle back, or OUT (counterclockwise) to allow the axle to move
forward.
:
NOTE If adjuster screws or nuts are turned OUT (counterclockwise)
push the wheel and axle forward to be sure the end of adjuster screws
or the nuts are seated against the end of the swingarm before inspecting
alignment or belt tension.
7. Recheck rear wheel alignment after each adjustment. Readjust
if necessary until alignment is correct and drive belt tension is
correct (see Check Drive Belt Tension, page 92).
98
4
5
6