RAM Cargo Van 2014 Owner's Manual page 201

6. Press and release the SET (S) button located on the
driver's door.
7. Within five seconds, press and release MEMORY
button 1 or 2 on the driver's door. The next step must
be performed within five seconds if you desire to also
use a RKE transmitter to recall memory positions.
8. Select "Remote Linked to Memory" in the Electronic
Vehicle Information Center (EVIC) and enter "Yes".
Refer to "Electronic Vehicle Information Center
(EVIC)/Customer-Programmable Features" in "Un-
derstanding Your Instrument Panel" for further infor-
mation.
9. Press and release the LOCK button on one of the RKE
transmitters.
10. Insert the ignition key and turn the ignition switch to
the ON position.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 199
11. Repeat the above steps to set the next Memory
position using the other numbered Memory button or
to link another RKE transmitter to memory.
Memory Position Recall
NOTE: The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the vehicle is not
in PARK, a message will be displayed in the EVIC.
To recall the memory settings for driver one, press
MEMORY button 1 on the driver's door or the UNLOCK
button on the RKE transmitter linked to memory position
1.
To recall the memory setting for driver two, press
MEMORY button 2 on the driver's door or the UNLOCK
button on the RKE transmitter linked to Memory Position
2.
A recall can be cancelled by pressing any of the
MEMORY buttons on the driver's door during a recall (S,
3