Philips RQ1200 series User Manual page 21

Using the Jet Clean system
Note: If you use the shaver with shaving foam or
shaving gel, we advise you to rinse it under the hot
tap before you clean it in the Jet Clean System. This
guarantees an optimal lifetime for the cleaning fluid.
1 Hold the shaver upside down above the holder
with the back of the shaver pointing towards
the holder.
2 Place the shaver body in the holder behind the
two clips (1) and press it down until it locks
into place (2).
, The display shows that the shaver is charging
(see chapter 'The display').
3 RQ1008: Press the up/down button to select a
cleaning program.
4 Press the on/off button on the Jet Clean
System to start the cleaning program.
, The shaver display stops showing the charging
indication.
, The cleaning light starts to flash and the shaver is
automatically lowered into the cleaning fluid.
, The cleaning light flashes throughout the
cleaning program, which takes a few minutes.
Note: RQ1007: The cleaning program takes 4 to 6
minutes.
Note: RQ1008: The auto and eco cleaning programs
take 4 to 6 minutes. The intensive program takes
approx. 35 minutes.
English
21