Regulatory Compliance - Control 4 SR-250 Setup Manual

•
Beep until button press—The System Remote Control beeps until you press
one of its buttons.
•
Beep for X seconds (<254)—The System Remote Control beeps until X
seconds have elapsed, or you press one of its buttons.
•
Stop Beep—The System Remote Control stops beeping.

Regulatory Compliance

IMPORTANT! Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
IMPORTANT! Tous les changements ou modifications pas expressément
approuvés par la partie responsable de la conformité ont pu vider
l'autorité de l'utilisateur pour actionner cet équipement.
FCC/Industry Canada
FCC ID: R33C4SR250Z/Canadian IC:7848A-C4SR250Z
This device complies with Part 15 of the FCC Rules Sub-Part B and C with Canada
ICES-003 and RSS-Gen. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation of this device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
™
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to whi
the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Australian/New Zealand Compliance
•
AS/NZS 4268:2003 + A1:2005 & A2:2006.
Limited 2-Year Warranty
For complete warranty information, including details on consumer legal rights
as well as warranty exclusions, visit www.control4.com/warranty.
Recycling
For information on recycling, please go to
www.control4.com/recycling.
China RoHS
About this Document
Part Number: 200-00071 Rev. G 2/11/2011