Connection Diagrams - Blaupunkt TravelPilot RNS 149 Installation Instructions Manual

Installation instructions
pressure on the side of the plug (see
Fig. 7).
Note: Once the handles have locked
into place, they cannot be removed
until you pull the TravelPilot out of the
compartment.
4.5 Connecting the back-up light
signal wire
The back-up light signal wire connects
the system to the vehicle back-up light.
Make sure that this connection is
charged with 12 volts when the vehi-
cle is reversing.
Important: We assume no liability for
faulty connections and their conse-
quences!
4.6 Connecting the speedometer
signal
Important : Only an authorised cus-
tomer service centre should make this
connection.
The speedometer signal wire connects
the system to the vehicle-specific
speedometer signal connection.
Important : We assume no liability for
faulty connections and their conse-
quences!

5. Connection diagrams

Power connection to the
vehicle ISO standard plug ......... Fig.1/2
Power connection to
the vehicle-specific plug ............ Fig.3
Speaker connection
4 speakers (4 Ω/35 W) .............. Fig.4
Antenna connection ................... Fig.5
TravelPilot installation ............... Fig.6/6a
TravelPilot removal .................... Fig.7
Setting the gyroscope ................ Fig.8
Connection assignments ........... Fig.9
Connecting the sensors ............. Fig.10
4