Key Dimensions And Specifications; Location Requirements; Choose The Proper Location; Clearances - Kenmore ELITE 796.8051 Series Use And Care Manual

Use & care guide and mnstajjation mnstructions
Hide thumbs Also See for ELITE 796.8051 Series:
Table of Contents

Advertisement

Available languages

Available languages

I
I
KEY DIMENSIONS
AND SPECIFICATIONS
Description
Dryer (Gas and Electric)
Electrical Requirements
Please refer to the rating label.
Gas Requirements*
NG:
6-8 in. WC
Gas Requirements*
LP:
10-13 in. WC
Dimensions
27" (W) X 28 11/16" (D) X 38" (H), 52 1/4" (D With door open)
68.60m (W) X 76.7cm (D) X 96.50m (H), 132.7cm (D With door open)
Net Weight
Electric: 139 lb. (63.1kg) Gas: 142.4 lb. (64.6kg)
Drying Capacity
IEC 7.4 cu. ft.
*Gas Models only.
LOCATION REQUIREMENTS
IMPORTANT:
Read all installation instructions completely before
installing and operating your dryer!
It is important that you review this entire manual before
installing and using your dryer. It contains detailed
instructions concerning electrical connections,
gas con-
nections and exhaust requirements.
I
20 3/20"
(56.2 cm)
CHOOSE THE PROPER LOCATION
• Store and install the dryer where it will not be exposed
(1
to temperatures below freezing or exposed to outdoor
weather conditions.
• Choose a location with a solid, level floor.
• If the dryer is being installed in a garage, place the
dryer at least 18 in. (45.7cm) above the floor.
• Properly ground the dryer to conform with all governing
codes and ordinances.
• To reduce the risk of electric shock, do not install
the dryer in damp or wet locations.
IMPORTANT: If you are installing your dryer in a
manufactured or mobile home, please refer to the
3"
section Special Electrical Requirements for Mobile or
Manufactured Homes on page 12,
(7.6 cm)
CLEARANCES
• Most installations require a minimum 5-1/2 in.
(14 cm) clearance behind the dryer for
the exhaust ducting.
• Allow minimum clearances of at least 1 in.
(2.5 cm) on the sides and back to minimize
vibration and noise.
• Allowing additional clearance for installation
and servicing is recommended.
• Be sure to allow for wall, door, or floor moldings
that may increase the required clearances.
• Allow at least 21 in. (53.3 cm) in front of the dryer
to open the door.
48 sq in. /
(310 cm)
34 sq in.
(155cm)"
i
oL
/' /
,, t<
io
I
1
(2.5 cm)
27"
(2.5 cm)
(68.6 cm)
Additional Instructions for
closet installations:
• The closet door must allow
for sufficient airflow. Refer to
the diagram to the left for
minimum vent opening
requirements. A Iouvered
door is also acceptable.
(7.6 cm)
Closet Door Vent
Requirements
8
I
I

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite 796.9051 series

Table of Contents