Spark Plug - Honda XL200 Owner's Manual

48
5. Install the oil strainer screen, spring and drain plug.
Oil Drain Plug Torque:
15 N·m (1.5 kgf.m, 11 lbf·ft)
6. Fill the crankcase with the recommended grade oil;
approximately:
1.1 l (1.2 US qt , 0.9 Imp qt)
7. Install the oil filler cap.
8. Start the engine and let it idle for 2 – 3 minutes.
9. Stop the engine and check that the oil level is at
the upper level mark on the dipstick with the
motorcycle upright on firm, level ground. Make sure
there are no oil leaks.

Spark Plug

(Refer to the Safety Precautions on page 41.
Recommended plugs:
Standard: DP8EA – 9 (NGK) or
X24EP – U9 (DENSO)
For cold climate: (Below 5°C, 41°F)
DP7EA – 9 (NGK) or
X22EP – U9 (DENSO)
For most riding conditions this spark plug heat range
number is satisfactory. However, if the motorcycle is
going to be operated for extended periods at high
speeds or near maximum power in hot climates, the
spark plug should be changed to a colder heat range
(a higher number).
NOTICE
Never use a spark plug with an improper heat range.
Severe engine damage could result.
Owner´s Manual
)