Assembly - Weslo WCTL29509.0 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
In addition to the included hex keys
adjustable wrench
ware used during assembly. Note: If a part is not in the hardware kit, check to see if it has been preattached
to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic parts, do
not use power tools for assembly.
16mm Screw
18mm Screw (58)–2
(85)–2
M5 Star
Washer (7)–2
M8 Star
Washer (5)–6
M10 Star
Washer (9)–2
1. Make sure that the power cord is unplugged.
Place a piece of cardboard under the tread-
mill frame to protect the floor during assem-
bly.
Have a second person hold the Base (52) in the
position shown.
Attach six Base Feet (63) to the Base (52) with
six 19mm Tek Screws (26).
, assembly requires a Phillips screwdriver
, and needlenose pliers
19mm Screw (10)–4
Washer (32)–4
M10 Flat
Washer (14)–2
M8 Nut (46)–2
M8 Flat
Washer (72)–4
M6 Nut (43)–4
G
. Use the drawings below to identify the hard-
M6 Flat
M10 x 110mm Bolt (1)–2
1
26
63
6
M8 x 15mm
19mm Tek
Screw (26)–6 Bolt (8)–6
M8 x 52mm Bolt (82)–2
M6 x 58mm Bolt (13)–4
M10 x 58mm Bolt (2)–4
26
63
26
52
63
26
63
U
, an
26
63