Table of Contents
Advertisement
Most communication software follows the following IRQ settings and I/O address
settings:
IRQ Number
COM1:
COM2:
COM3:
COM4:
If you are using Windows 3.x, you can change the IRQ from the CONTROL PANEL
- PORTS - ADVANCED dialog box. If you change the COMPORT and IRQ under
Windows, be sure the settings match the parameter in the MDMEN.EXE command
line.
Windows NT 4.0
Follow the steps below to configure your Comet using Windows NT 4.0.
1. Insert the fax/modem card into the PCMCIA slot, and make sure it is firmly seated.
2. Turn on your computer and start Windows NT 4.0.
3. From the Control Panel double click the Modem Icon.
4. From the Install New Modem dialogue box, click the Next button.
5. Select Standard modem and click the Next button.
6. Click the Finish button.
Using INF File in the Bundled Diskette
1. Insert the fax/modem card into the PCMCIA slot, and make sure it is firmly seated.
2. Turn on your computer and start Windows NT 4.0.
3. From the Control Panel double click the Modem Icon.
4. From the Install New Modem dialogue box, click the Next button.
5. Click the Change button to change the modem type.
6. Click the Have Disk... button.
7. Insert the INF file disk bundled with the fax/modem PC Card into the floppy drive.
8. Enter the path A:\ and click the OK button.
9. Click OK to accept the modem type PCMCIA 33.6kbps FAX + Modem.
6 Installation
I/O Address
4
3F8
3
2F8
4
3E8
3
2E8
Advertisement
Table of Contents
