Scantronic 4601 Installation And User Manual page 7

4600
To change:
Zone Options
(n = zone number)
Press Clear to clear zone
of any existing options.
Carrier Jamming Detect†
Bell Test
Strobe Test
Panel sounder test
Load defaults
Leave Programming
*Any = press any numbered key to toggle the option on or off. Zone 8 LED indicates
the status of the current selection (LED glowing function ON).
† Not available on earlier versions of software.
Notes:
1. While entering the new password, zone 1 LED flashes.
2. Zone 2 LED glows and zone 8 LED shows the status of the Consecutive
Code Checking function.
3. Zone 3 LED glows and zone 8 shows the status of the Instant Night Mode
(LED glowing-Function ON). Instant Night Mode only affects entry/exit zones
that are also part-set zones. If the mode is ON, part-set entry/exit zones
become instant alarm zones, rather than entry/exit zones during part-set mode
only. If the mode is OFF, the part-set entry/exit zones are entry/exit zones as
normal. This mode has no affect in the full-set mode or on entry/exit zones that
are not part-set zones.
4. Unless Entry Route zones are included, DO NOT select the First Zone
Lockout function, as an entry fault would make it impossible to unset the panel
without first creating an alarm condition.
5. The 4600 system features a two-ply entry time. After the selected entry time
has expired, the system will enter into an internal alarm for a period equal to
50% of the selected entry time. If the panel is not unset by entering a valid
code by the time the 50% extra time has expired, the system will enter into a
full alarm condition (internal sounders/external bell and strobe).
6. If you do not select an option for a zone it becomes a Normal Night zone.
The system will not let you select certain options together, for example: entry
route and PA zone.
You must select Auto restore for PIRs, smoke detectors, Viper detectors, and
PAs.
7. Press Enter to end test prematurely.
Key in: Then: Notes
5n 1 = Double knock
ENTER
2 = Chime
3 = Auto Restore
4 = Entry Route
5 = Personal Attack
6 = Entry/Exit
7 = Part Set
8 = Fire
Press after making selections.
ENTER
65 Any* Zone 8 LED shows status
ENTER ENTER
91 Bell sounds for 10seconds (see note 7)
ENTER
92 Strobe active for 60seconds (see note 7)
ENTER
93 Panel sounder active for 10secs (see note 7)
ENTER
98
ENTER
99
ENTER
496368 Issue 1
Engineering Program Commands
Default
(see note 6)
ON
7 of 12