Scantronic 4601 Installation And User Manual page 6

Engineering Program Commands
Zone 1 Entry/Exit zone/part set/auto restore (PIR)
Zone 2 Part set/entry route zone/auto restore (PIR, VIPER)
Zone 3 Part set/entry route zone/auto restore (PIR, VIPER)
Zone 4 Auto restore (PIR, VIPER)
Zone 5 Auto restore (PIR, VIPER)
Zone 6 Nothing selected (i.e., full set only door contact)
Zone 7 PA/auto restore (Pendant or hand-held PA)
Zone 8 Fire/auto restore
All other defaults are shown in the Engineer Program Command list by a ' '.
Engineering Program Commands
To change:
Engineer Access Code
Consecutive Code Jamming 32
Instant Night Mode
Remote Set
First Zone Lockout
Part Set Exit Timer
Bell Duration Timer
Entry Timer
Full Set Exit Timer
6 of 12
Key in: Then: Notes
20 nnnn See note 1
ENTER ENTER
Any* See note 2
ENTER ENTER
33 Any* See note 3
ENTER ENTER
34 Any* Zone 8 LED shows status
ENTER ENTER
35 Any* See note 4
ENTER ENTER
41 1 = 10 seconds
ENTER ENTER
2 = 20 seconds
ENTER
3 = 40 seconds
ENTER
4 = 60 seconds
ENTER
5 = Continuous
ENTER
6 = Instant (1.5s bleep
ENTER
followed by 20s silent)
42 1 = 1.5 mins
ENTER ENTER
2 = 3 minutes
ENTER
3 = 5 minutes
ENTER
4 = 10 minutes
ENTER
5 = 15 minutes
ENTER
6 = 20 minutes
ENTER
7 = Continuous
ENTER
8 = 10s (for testing only)
ENTER
43 1 = 10 seconds (see note 5)
ENTER ENTER
2 = 20 seconds
ENTER
3 = 40 seconds
ENTER
4 = 60 seconds
ENTER
44 1 = 10 seconds
ENTER ENTER
2 = 20 seconds
ENTER
3 = 40 seconds
ENTER
4 = 60 seconds
ENTER
5 = Continuous
ENTER
6 = Final door or 60 seconds
ENTER
496368 Issue 1
4600
Default
7890
ON
OFF
ON
ON