ZyWALL 35 User's Guide
Figure 218 Configuration Upload Error
25.10.3 Back to Factory Defaults
Pressing the Reset button in this section clears all user-entered configuration information and
returns the ZyWALL to its factory defaults as shown on the screen. The following warning
screen will appear.
Figure 219 Reset Warning Message
You can also press the RESET button on the rear panel to reset the factory defaults of your
ZyWALL. Refer to
25.11 Restart Screen
System restart allows you to reboot the ZyWALL without turning the power off.
Click MAINTENANCE, and then Restart. Click Restart to have the ZyWALL reboot. This
does not affect the ZyWALL's configuration.
410
Section 2.3 on page 58
for more information on the RESET button.
Chapter 25 Maintenance