Installation Instructions - Yale EIS1100 User Manual

Installation instructions

WARNING: DURING INSTALLATION
YOU WILL BE ASKED TO DRILL A 32mm
HOLE ON YOUR DOOR OF WHICH
IS PERMENANT AND IRREVERSIBLE.
SHOULD YOU NOT WISH THIS TO
HAPPEN PLEASE DO NOT PROCEED
WITH INSTALLATION. PLEASE BE
AWARE OF THIS CONSEQUENCE AS
WE CANNOT BE HELD LIABLE FOR ANY
DAMAGES RESULTING FROM DRILLING
THE DOOR.
Do not point camera in the direction of the
sun. Please note varying position of sun
throughout the year.
1. Decide on the position of the door
viewer on the door, the camera should be
high enough to see the face of the caller
outside and the LCD viewer at a suitable
height for viewing inside. Beware that if
the camera is fitted too high it might not
be possible to see below a certain height,
i.e. child visitor. If necessary, reconnect the
viewer to the camera so that the angle of
the camera can be observed (See previous
steps).
2. Using a suitable drill bit for your door,
drill a 32mm (1 ¼") diameter hole, from
both sides of the door in the required
position.
Diy tip: Drill through the door until the
tip of the drill bit breaks through the other
side then finish by drilling through from the
other side of the door.
Important: If fitting to a plastic or reinforced
door, please check with the door
manufacturer before drilling the door.
3. Place the rubber O-ring over the
camera. The cable should have been
already inserted into the camera in
previous steps. If not, carefully insert the
connecting cable squarely into the back of
the camera, blue side up and in as far as
the black line.
4. Select and insert screws of a suitable
length (depending on the thickness of
the door) into the back of the camera
(4 lengths supplied). Test the camera in
the drilled hole to check that the screws
JUST reach through to the other side of
the door, try longer or shorter screws as
required. Remove the camera.
5