Summary of Contents for Yale Real Living Look Door Viewer
Page 1
Yale Real Living ® Look Door Viewer with WiFi ™ Installation Instructions VIEWER SIDE Optional with 9/16" drill bit 1.5" 4.3" 105˚ Screen 2.75" 9/16" AYRLDVINSTFUL_RevB...
Page 2
Preparing Door Remove Existing Hardware Typically 9/16" 55-1/2" Drill Bit From Floor AYRLDVINSTFUL_RevB...
Installing Camera Outside of Door Installing Mounting Bracket Inside of Door Select Screws Based on Door Thickness Set A: 1-3/8" to 1-3/4" Door Set B: 2" to 2-3/4" Door E R S ID V IE W AYRLDVINSTFUL_RevB...
Page 4
Connecting Camera to Viewer Remove protective cover from wire adaptor. Ensure UP arrow on cable is oriented toward top of monitor. Snap wire adaptor to connector on backside of monitor. Mounting Viewer Tuck excess wire into monitor cavity to ensure it does not get pinched.
Installing Micro SD Card Micro SD Look Door Viewer will not function without SD card installed. Congratulations, you've installed the ® Yale Real Living Look Door Viewer™! NOTE: Look Door Viewer will not function properly until configured with Look App. AYRLDVINSTFUL_RevB...
Page 7
Look Door Viewer Programming ™ Battery Pack Battery SD Card Power Reset Slot Button Button HD Camera Microphone Motion Detector Speaker 2 Way Com Doorbell AYRLDVINSTFUL_RevB...
Yale Look App Look Door Viewer will not function properly until configured with Look App. Download the free Yale Look app from the Google Play Store or App Store. Setting Up Your Device After downloading the application, follow the on-screen instructions.
Page 9
Definitions: *Please note all adjustments to the Look™ Door viewer are made via the mobile application. Low Battery: The low battery light will flash when your Look Door Viewer™ batteries are low. You will also receive a notification via your mobile app. Motion Detection: Turn motion detection on to activate the camera as a visitor approaches the door.
Charging the Battery Pack Plug the supplied USB micro cable into USB port on battery pack. A USB micro 5v charger with 1 AMP minimum output is required for proper charging. LED will glow red when charging and turn green when charged. Port Resetting Look Door Viewer ™...
Troubleshooting Symptom Suggested Action Screen doesn’t turn on or Check cable connection. is fuzzy Unit doesn’t power up Recharge battery pack. Not receiving Images/Video Confirm SD card is installed. Device LED is flashing blue Device is in WiFi Direct mode- and red Configure with app Device is flashing red and...
Page 12
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications to this device, not expressly approved by Yale Security Inc. could void the user's authority to operate the equipment.