Salt Indicator - Miele Touchtronic Premier Plus HG01 Operating Instructions Manual

Before using for the first time

Salt indicator

When the salt reservoir is empty, the
"Salt-PC" indicator will light, indicating
that it should be refilled with reactiva-
tion salt.
After the reservoir has been filled, the
water softener is automatically reacti-
vated the next time the dishwasher is
started. The "Salt" indicator will light
during this process.
16
Bypassing the salt indicator
If your water is soft (below 8 gr/gal) the
salt reservoir should not be filled with
salt. The indicator will remain lit and
should be disregarded or bypassed.
^ Remove the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
right hand side, a.
^ Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
^ Using needle nose pliers, first pull the
cap, b, off of the float chamber, then
remove the float, c.
^ Replace the float chamber cap, push
the chamber back into its upright po-
sition, and replace the salt reservoir
cap. The indicator should not light.