SRAM BOXXER TEAM 2015 Service Manual page 11

Clamp the drive side upper tube into a bicycle stand.
5
6 Use a 2.5 mm hex wrench to loosen the set screw and remove the
rebound adjuster knob located at the bottom of the drive side
lower leg.
Use a 5 mm hex wrench to loosen the drive side bottom bolt 3 to
7
4 turns.
8 Place an oil pan beneath the fork to catch any draining fluid.
Use a plastic mallet to firmly strike the drive side bottom bolt to
dislodge the rebound damper shaft from the lower leg.
Use a 5 mm hex wrench to remove the bottom bolt from the lower
leg.
Do not dislodge the silver casting plug from the drive side lower
leg.
Drive side
2.5 mm
5 mm Loosen 3 to 4 turns
5 mm
Plastic mallet
Lower Leg Removal 11