Heat & Glo SOHO-N-CEB Owner's Manual And Installation Manual page 49

Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modifi cation of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fi re hazard.
• Read, understand and follow these instructions for safe
installation and operation.
Fireplace Specifi c Information
Standard fi replace features vary. Consult the installation
manual for available options.
The optional AUX300CE receiver provides additional fea-
tures: Fan control and two Aux functions.
The REM300-HNG-CE remote control system functions
include: On/Off, Thermostat Mode, Timer Countdown,
and Flame Adjustment (for fi replaces with variable fl ame).
Kit Contents
REM300-HNG-CE
• REM300-HNG-CE Transmitter
• AAA Batteries (3)
• Wall Holder
• Drywall Anchor (2)
• Screws (2)
Heat & Glo • SOHO-B-CEB, SOHO-N-CEB, SOHO-P-CEB • 2111-980 Rev. F • 8/11
Introduction
The RC300CE multifunctional remote control is de-
signed to control pilot light, fl ame height, blower speed,
and up to two 230 VAC auxiliary functions on your gas
fi replace. The RC300CE is equipped with thermostat
functions which can automatically control the tempera-
ture in the room in which it is installed. The control is
only for use with the Hearth & Home Technologies In-
telliFire Plus™ system (IPI). The AUX300CE module is
rated for 230 VAC, 50-60 Hz, and is required for operation
of this remote control device.
Installation Precautions
The installation of this remote control must be performed
by a qualifi ed service technician. This remote control is
tested and safe when installed in accordance with this
installation manual. Do not install any components that
may be damaged.
Do not modify, disassemble, or substitute any of the com-
ponents included with this kit. Installation of this unit must
be done by a qualifi ed service technician.
Placement of this remote control may affect performance.
An assessment of the space should be done prior to in-
stallation for optimum performance.
Determine Location
Determine the location for the remote control. The selected
location should be in the same space as the gas fi replace.
Never place this unit in a separate room. The remote control
must be placed within 30 feet (9,14 m) of the fi replace but
should not be exposed to extreme heat.
The RC300CE is approved for interior installation and
should not be used in exterior applications.
• Keep remote control out of reach of children.
49