Martin MAC Viper Performance User Manual page 29

Menu level 1 Menu level 2
FOCUS
FOCUS FINE
MANUAL
PAN
CONTROL*
PAN FINE
(continued)
TILT
TILT FINE
ERROR LIST
FAN CLEAN
PT FEEDBACK
ADJUST
SERVICE
CALIBRATION
FIRMWARE
UPDATE
* Menus marked * are available only when the fixture is connected to mains power. All other menus are available in mains- and
battery-powered operation.
Menu level 3 Menu level 4
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
Empty or up to 20 errors
ON/OFF
ON
OFF
ADJUSTED/
DIMMER
NOT ADJUSTED
NOT ADJUSTED/
FROST
1 - 255
ADJUST
RESET/FRAMING
FRAMING BLADE 1
LEFT...FRAMING
BLADE 4 RIGHT
PT AT END STOP ACTION
DIMMER ... TILT
LOAD DEFAULTS
SAVE DEFAULTS
NO DEVICE
UPDATING FILES
PERFORMANCE
1.0.0
AVAILABLE
...
FIRMWARE
PERFORMANCE
X.X.X
Table 2: Control menus
Control panel menus
Notes (Default settings in bold print)
Set focus
Set focus, fine (LSB, default = 128)
Set pan angle (default = 128)
Set pan angle, fine (LSB, default = 128)
Set tilt angle (default = 128)
Set tilt angle, fine (LSB, default = 128)
Display any errors in memory
Activate fan cleaning
Enable pan/tilt position feedback
systems
Disable pan/tilt position feedback
Important! For use by authorized
service technicians during mechanical
adjustment only. Do not enter the
ADJUST menu without Martin™ service
documentation, or you may make the
fixture impossible to use correctly.
Jog wheel must be held in for 5 seconds to
enter.
Calibrate pan/tilt sensor by turning pan
clockwise against end stop, and tilt against
end stop pointing away from display, then
push ACTION
Set individual effects to calibration
positions (approx. +/- 5% offset available)
Load factory default calibration settings
Replace factory default calibration settings
with current calibration settings
No USB device present or no firmware on
USB device
Fixture updating internal memory from
USB device
Select firmware from versions stored in
internal memory. Select version, then click
on jog wheel and confirm your choice to
update
29