Set Character Precision; Set Character Set; Set Color - IBM 6400 Programmer's Reference Manual

Hex
03
04

Set Character Precision

39
Description: This order sets the value of the current character precision
attribute. Parameter P1 specifies the type of precision.
Table 83. Set Character Precision
Byte Value
0 X 39
' '
1
X ' 00 '
X 01
' '
X 02
' '
X 03
' '

Set Character Set

38
Description: This order sets the value of the current character set attribute.
The character set specified by this command must use an NLQ font if printing
high-density graphics or a DP font if printing low-density graphics.
Parameter P1 specifies the local character set identifier. This local ID is mapped
to a global font ID by the Load Font Equivalence command. See "Load Font
Equivalence (LFE)" on page 34.
Table 84. Set Character Set
Byte Value
0 X 38
' '
1
X 00
' '
X 01 -X
' '
X FF
' '

Set Color

0A
Description: This order sets the value of the current graphics color attribute.
The color for non-graphics (for example, text) does not change with this order.
The color attribute applies to all following graphics drawing orders until another
Set Color order or Set Extended Color order occurs or until a new graphics
segment initializes the graphics attributes. This order does not change any
other graphics drawing attributes.
Line Type
Right to Left
Bottom to Top
P1
Description
Order code
Precision Type
Drawing default
String Precision
Character Precision
Stroke Precision
P1
Description
Order code
Local Character Set ID (LCID)
Drawing default
FE Local ID (LCID) for Character Set
' '
Special Character Set
P1
Graphics Command Set
Chapter 3. IPDS Commands Reference
Error Code
X ' 0300..04 '
X ' 0300..0E '
Error Code
X ' 03C3..00 '
111