Operation; Fault/Function Indicators - HSM securio P36 Operating Instructions

Operation

Switching on the shredder
• Press the on/off button.
 The "Ready for operation" indicator lights up.
Shredding paper
• Feed the paper to the middle of the paper
slot. The light barrier starts the cutting unit
automatically. Therefore, with thin paper
strips, make sure the light barrier detects
them.
Note: Do not shred paper in the CD cutting
unit. This can cause damage.
 3 seconds after the light barrier in the paper
feed opening is free again, the cutting unit is
switched off automatically and the shredder
switches to standby.
Destroying CDs, credit cards and
fl oppy disks
• Check whether your machine is certifi ed for
destroying these materials (see "Intended
use").
• For machines with a separate CD cutting unit
(optional), put the material in the feed slot of
this cutting unit. This protects you from splin-
ters. Otherwise, use the paper cutting unit.
Switching off the shredder
• Press the on/off button.
 The "Ready for operation" indicator goes out.
4
Other function modes:
• Brief mode 10 s
Application: Destroying small pieces of paper
Function: The cutting unit runs for approx.
10 seconds and is then switched off auto-
matically.
Start: Press the on/off button for 2 seconds.
To cancel: Press the on/off button.
• Permanent mode
Application: Destroying large quantities of
CDs and paper
Function: Cutting unit runs continuously.
If no material is fed in within a period of
3 minutes, the cutting unit shuts down and
the shredder switches to standby.
Start: Press the on/off button for at least
4 seconds.
To cancel: Press the on/off button.
• Sleep mode
Function: Two minutes after the last paper
feed operation, all consumers that are not
required are switched off automatically.
The „Ready for operation" indicator fl ashes
briefl y at regular intervals.
The shredder starts automatically when
paper is fed in.
• Automatic shutdown
Function: If the shredder is not used for one
hour, it shuts down completely and therefore
does not consume any more electricity (at
night, at the weekend).
Restart: Press the on/off button.
Fault and function indicators
Display Problem
Paper jam
Overload
Continu-
ous lamp
Flashes
Paper and
CD fed at
the same
time
Paper/
shredded
material
Continu- container
ous lamp full
Flashes CD con-
tainer full
Door or
safety ele-
ment open
Metal in the
paper
0906 0906
Measure
You have fed in too much paper.
 The cutting unit runs in reverse for a few seconds and pushes the
paper back out again.
• If necessary, press the reverse button "R" to remove the stack of
paper.
• Take half the stack of paper.
• Feed the paper in portions.
Note:
You can lift up the safety element in order to better remove paper.
To do this, press the middle section of the front of the safety element
and lift up the fl ap.
Note:
This indicator lamp also lights up when the motor is overloaded. In
this case, let the shredder cool down for 20 minutes before using it
again.
• Destroy paper and CDs/credit cards separately.
• Empty the paper/shredded material container.
Note:
If you press the reverse button briefl y before opening the door, part
of the material is pulled back into the cutting apparatus.
• Empty the CD container.
• Close the door or latch in the safety element.
• Press the reverse button and pull the paper put of the feed slot.
• Remove the paper clip and shred the paper again.
5