Troubleshooting; Cleaning; Components - HSM securio P36 Operating Instructions

Display Problem Measure
Oil reservoir • Fill the reservoir with cutting apparatus oil.
empty
1.850.999.500
1
Aufkleber
„Hersteller-Öl verwenden"
2
Display Function Activate/deactivate
Button lock To activate or deactivate the button lock
is activated
• Press and hold the reverse button
• Press the on/off button
• Release the on/off button and then the reverse button
Notes
Manual reversing
If you press the reverse button, the cutting unit
runs in reverse and switches off after 2 sec-
onds, even if you keep the button pressed. To
reverse manually, release the button and press
it again.
If the shredder is already running forward,
pressing the button immediately reverses it.
Shredded material container
Both cutting units stop when the paper or CD
container is full.
The CDs and credit cards fed into the machine
are counted. Once the maximum number has
been reached, the machine switches off and a
signal is emitted. The counter is automatically
reset if the door is open for longer than 5 sec-
onds after the signal. In addition, a light barrier
monitors for blockages on the material chute.
Automatic oiler (cross cut only)
The cutting units are oiled for 1.5 seconds after:
• The cutting unit is in operation for 200 sec-
onds (corresponding to 50 paper shreds)
• The cutting unit runs forwards after the
reverse button has been pressed
The "Oil reservoir empty" signal is automati-
cally deactivated after the reservoir is fi lled. The
shredder remains operational even when the oil
reservoir is empty.
6
Only use HSM special oil.
Reservoir volume: 250 ml
Press the safety element and lift up the fl ap.
The oil fi lling opening is to the right of the feed
chute.
You can fi ll the oil either through the small open-
ing 1 (take out the yellow plug) or the normal
opening 2 (unscrew the red cap).
Metal detection (optional)
To prevent paper clips from damaging the cut-
ting unit, the machine is equipped with a metal
detection system.
Cleaning and maintenance
Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
must enter the equipment.
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer:
• Spray special cutting apparatus oil through the
paper feed opening along the entire width on
to the cutting rollers.
• Let the cutting unit run without paper in brief
mode.
Paper dust and particles are shaken off.
Machine components
Note: Depending on the version, your machine may not include all the assemblies.
1 2
1 Feed slot for CDs and credit cards (optional)
2 Safety instructions
3 Light barrier in the paper feed
4 Safety element
5 Operating and display unit
6 Holder for operating manual and oil bottle
7 Shredded material for CDs and credit cards
(optional)
8 Filler opening for cutting apparatus oil
(cross cut only)
Operating and display elements
Note: depending on the machine ver-
sion, not all functions may be available.
Indicator: door open
or safety element not
latched
Indicator: overload
(paper jam)
Indicator: paper/CD
container full
0906 0906
3 4 5
6
8
7
Reverse button
Indicator: oil reservoir empty
Function button
"On/off/start"
Indicator: metal detection
Indicator: button lock
Indicator: ready for
operation /
Sleep down
3