Operation; Starting Up The Projector - Canon LV-WX300 User Manual

Operation

Starting up the projector

1. Plug the power cord into the projector and into a wall socket. Turn
on the wall socket switch (where fitted). Check that the POWER
indicator light on the projector lights orange after power has been
applied.
• Ask your installation specialist to provide an Earth leakage
breaker. When you do not use the projector, be sure to shut
down the main power by the breaker.
• Please use the original accessories (e.g. power cord) only with
the device to avoid possible dangers such as electric shock
and fire.
• In order to ensure the safety in case of trouble with the
projector, use an electrical outlet having an earth leakage
breaker to supply the power to the projector. If you do not have
such outlet, ask your dealer to install it.
2. Remove the lens cap.
3. Press POWER on the projector or remote control to start the
I
I
projector. The POWER indicator light flashes green and stays
green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage
of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
• If the projector is still hot from previous activity, it will run the
cooling fans for approximately 90 seconds before energizing
the lamp.
• To maintain the lamp life, once you turn the projector on, wait
at least 5 minutes before turning it off.
• After POWER is pressed, the image may flicker before the
I
I
lamp becomes stable. This is not a product malfunction.
4. If the projector is activated for the first time, select your OSD
language following the on-screen instructions.
5. If you are prompted for a password, press the arrow keys to enter
a six-digit password. See
page 30 for details.
6. Switch all of the connected equipment on.
7. The projector will start to search for input signals. The current
input signal being scanned appears in the upper left corner of the
screen. If the projector doesn't detect a valid signal, the message
'No Signal' will be displayed until an input signal is found.
You can also press INPUT on the projector or remote control to
select your desired input signal. See
page 32 for details.
If the frequency/resolution of the input signal exceeds the
projector's operating range, you will see the message 'Out of
Range' displayed on a blank screen. Please change to an input
signal which is compatible with the projector's resolution or set
the input signal to a lower setting. See
for details.
28
"Utilizing the password function" on
"Switching input signal" on
"Timing chart" on page 69