Magnifying And Searching For Details; Selecting The Aspect Ratio - Canon LV-WX300 User Manual

Magnifying and searching for details

If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys
for navigating the picture.
• Using the remote control
1. Press D.ZOOM +/- to display the Zoom bar.
2. Press D.ZOOM + to magnify the center of the picture. Press the
key repeatedly until the picture size is suitable for your need.
3. Use the directional arrows ( ,
remote control to navigate the picture.
4. To restore the picture to its original size, press AUTO PC. You
can also press D.ZOOM -. When the key is pressed again, the
picture is further reduced until it is restored to the original size.
• Using the OSD menu
1. Press MENU and then press
2. Press to highlight D.ZOOM and press OK/IMAGE. The Zoom bar is displayed.
3. Repeat steps 2-4 in the section of
control panel, continue to the following steps.
4. Press on the projector repeatedly to magnify the picture to a desired size.
5. To navigate the picture, press OK/IMAGE to switch to the panning mode and press the directional
arrows ( ,
6. Use the directional arrows ( ,
7. To reduce size of the picture, press OK/IMAGE to switch back to the zoom in/out functionality, and
press AUTO PC to restore the picture to its original size. You can also press
restored to the original size.
The picture can only be navigated after the picture is magnified. You can further magnify the picture
while searching for details.

Selecting the aspect ratio

The 'aspect ratio' is the ratio of the image width to the image height. Most analog TV and computers are in
4:3 ratio, and digital TV and DVDs are usually in 16:9 ratio.
With the advent of digital signal processing, digital display devices like this projector can dynamically
stretch and scale the image output to a different aspect than that of the image input signal.
To change the projected image ratio (no matter what aspect the source is):
1. Press MENU and then press
2. Press to highlight Aspect.
3. Press / to select an aspect ratio to suit the format of the video signal and your display
requirements.
,
/ until the DISPLAY menu is highlighted.
"Using the remote control"
, , ) to navigate the picture.
,
/ until the DISPLAY menu is highlighted.
, ) on the projector or
, ) on the projector or remote control to navigate the picture.
above. Or if you are using the projector
repeatedly until it is
35