Table of Contents
Advertisement
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure you have
made a correct connection to the projector audio input. See
input is connected.
Muting the sound
To temporarily turn off the sound, press MUTE on the remote control,
or:
1.
Press MENU and then press /
Advanced menu is highlighted.
2.
Press
to highlight Audio Settings and press OK/IMAGE. The
Audio Settings page is displayed.
3.
Highlight Mute and press /
Adjusting the sound level
To adjust the sound level, press VOL +/- on the remote control, or:
1.
Repeat steps 1-2 above.
2.
Press
to highlight Volume and press /
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do
not affect the projection settings, operation, or performance.
•
Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the length of
time the OSD will remain active after your last key press. The time length ranges from 5 to 30
seconds in 5-second increments. Use
•
Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD position
in five locations. Use
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD menus.
See
"Using the menus" on page 29
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed
during projector start-up. Use
Shutting down the projector
1.
Press
POWER and a confirmation message displays
I
I
prompting you.
If you don't respond in a few seconds, the message will disappear.
2.
Press
POWER a second time. The POWER indicator light
I
I
flashes orange, the projection lamp shuts down, and the fans will
continue to run for approximately 90 seconds to cool down the
projector.
3.
Once the cooling process finishes, the POWER indicator light
is a steady orange and fans stop.
4.
Disconnect the power cord from the wall socket if the projector
will not be used in an extended period of time.
•
To protect the lamp, we suggest you not to operate the
projector during the cooling process.
•
To shorten the cooling time, you can also activate the Quick Cooling function. See
Cooling" on page 57
•
Do not unplug the power cord before the projector shutdown sequence is complete or during
the 90-second cooling down process.
42
until the SYSTEM SETUP:
to select On.
/
to select a suitable time frame.
/
to select a preferred position.
for details.
/
to select a screen.
for details.
"Connection" on page 23
to select a desired sound level.
for how the audio
"Quick
Hide quick links:
Advertisement
Table of Contents
