Advertisement
4. Refitting the Main Chassis
The main chassis can be refitted to the mounting bracket assembly using the following
steps.
1.
Align the PCB at the top rear of the main chassis with the connector located at
the top of the mounting bracket assembly
2.
At the same time align the two tubes at the bottom rear of the main chassis
with the two tubes located on the bottom of the mounting bracket assembly.
3.
Slide the chassis backwards on the mounting bracket assembly so that the
PCB and connector and tubes engage simultaneously. (See diagram below).
4.
Ensure the PCB, connector and tubes are fully engaged by firmly pushing the
main chassis horizontally backward on the mounting bracket assembly
(WARNING: DO NOT PUSH ON THE LCD AS THIS MAY CAUSE DAMAGE).
5.
Align the two fixing screws located at the bottom of the chassis with the screw
threads on the mounting bracket assembly.
6.
Tighten the screws to secure the chassis to the mounting bracket assembly.
Diagram 5. Refitting the chassis.
CONNECTOR
PCB
TUBES
Advertisement
