To Install The Adapter Cable (Cars Without An On-Board Monitor Radio) - BMW 5 Series touring (E 39/2) LHD Installation Instructions Manual

7 .

To install the adapter cable (cars without an on-board monitor radio)

0
30
A3
A4
A5
0
X1108
0
0
31
B2
B
B1
A5
Retrofit / Installation kit No. 82 83 0 140 507
Installation Instructions No. 01 29 0 140 511
A
039 0095 B
30
A3
039 0096 B
18
30
A5
039 0097 B
30
19
039 0098 B
Issue date: 06.2001
Lay the adapter wiring harness A, as shown in the
0
figure, with branches A3 , A4 and A5 along the
main wiring harness to the installation of the
amplifier (30) and secure it with cable ties.
Pull up the carpet (30) in the driver's footwell.
0
Screw branch A3, brown cable with earth eyelet
6 mm to the earth post X1108 .
Lay branch A5 along the standard wiring harness
0
to the terminal 30 post (30) near the battery and
secure it with cable ties (18).
Lay branch A5, red cable strand on the radio/
0
amplifier adapter cable, along the standard wiring
harness to terminal 30 post (30) above the battery
(see installation and cabling diagram). Cut off
branch A5 , red cable strand, crimp on the contact
(19) and connect it to the fuse holder B1 on the
power supply cable with fuse B .
Screw branch B2 , 0.8 mm cable eyelet on the
power supply cable with fuse B to the screw-on
point (31) on the terminal 30 post (30).
Secure the fuse holder B1 to the standard wiring
harness with a cable tie.
EN/10