Advertisement
Do not try to close the lid by force. It can cause problems.
When opening/closing the lid.
1. Locate the handles of the inner pot
on the slot of the main unit.
(Refer to the following figure.)
2. Open and close the lid with
the Lock/Unlock handle located on
Unlock .
When the cooker is not properly cleaned, it can cause smells. Clean the lid frequently.
If there are any rice or alien substances on the oven packing or on the inner side of the inner pot,
it can cause the steam to leak. Therefore the rice may be under-cooked and crumbly.
Wipe both inside and
outside phases of the
inner pot to get rid of
any alien substances
or liquids
Wipe the lid with a wet cloth
that has been squeezed out
of all the water
If there is any alien substance
on the temperature sensor
carefully wipe it out trying not
to damage the metal plate
If the valve hole of the pressure weight part is clogged, punch it with the cleaning pin.
The valve hole of the pressure weight allowing the escape of steam should be checked regularly to ensure
that it is not blocked.
If you use the valve hole of pressure weight as it is blocked, the hot steam or any hot content within the
cooker can cause injury.
<How to clean the valve hole>
To remove the pressure weight : While
lock handle is at the lock position, turn
the pressure weight counter-clockwise
pressure
lifting it.
weight
Punch the clogged valve hole with the cleaning pin
cleaning
pin
which is placed on the bottom of the cooker.
Do not use the pin for any other purpose rather than the original use.
(Never poke it into other holes for they are SAFETY devices)
When cooking/warming the rice.
Cook and keep warm the rice with the
Lock/Unlock handle located on "Lock".
When steam is full inside the cooker, the
Lock/Unlock handle will not turn at this
time tilt the pressure weight and let the
steam out.
Check if there is any rice or alien
substance on the oven packing
Make sure you clean the steam
control vent before and after use
The edge of lid is made up of metal so
be careful when you clean the lid
Wipe the main unit with a wet cloth that
has been squeezed out of all the water
Do not use the inner pot for any other
purpose rather than the original use.
Do not place over any direct heat
source : flames, gas stoves, ect.
It can cause the transformation of
inner pot
It can cause to spill the inner coating
To reassemble the pressure weight in
after cleaning, put it and turn clockwise.
Reassembled properly, the weight can
pressure
be turned freely.
weight
Advertisement
