Advertisement
How to apply the warm temperature at my mode.
When opening the lid, if a lot of water drips from the lid bottom, or if the rice is too soft, try this.
Press "warm/reheat" button in my
mode. (Refer to page 15) The display of
mark will be changed with a buzzer
sound.
is the initial signal.
1. When opening the lid, if too much water drips :
2. If the edge of rice is too soft :
How to keep warm during sleep
When keeping the rice warm for a long time, set up the temperature low to prevent the following quality of
rice: smell, dry, change of color; from PM10:00 ~ AM 04:00.
How to set up
1. In the customized rice taste function, press the "warm/reheat" button. Then 'the customized
warming mode will be entered. Now, press the "Timer" button. The display will be shown
as below.
2. When entering the customized sleep warming, press the "Hr/SOAK" button.
display will be fixed and press the customized rice taste function to set up.
3. After entering the customized sleep warming, press the "Cancel" button or do not press any
button for 7 seconds if you desire to cancel the order.
4. Set it up to your taste since it is set off manufactured.
How to release
1. In the customized rice taste function, press the "warm/reheat" button. Then the customized
warming mode will be entered. Now, press the "Timer" button. The display will be shown as
below.
2. When entering the customized sleep warming, press the "Min/HEAT" button.
display will blink and then press the customized rice taste function if you want to cancel.
3. After entering the customized sleep warming, press the "Cancel" button or do not press any
button for 7 seconds if you desire to cancel the order.
If you need to keep the rice warm while you are sleeping, do not use this function. This function
makes the rice cooler than normal. In summer, the rice can go bad and smells because of high
temperature if possible do not use the customized sleep warming.
Press "Hr/SOAK" button to raise the setting mode about 1~2 step.
Press button "Min/Heat" to reduce the setting mode about 1~2 step.
-1 Press "Hr/SOAK" button to change the
display as
Select the menu you want, then the press the
"My Mode" button and set-up time will be
automatically entered with a buzzer sound.
(If you do not press a button within 7
seconds, the function will go back to the
previous function.)
-2 Press "Min/HEAT" button to change the
display as
Advertisement
