Using Lp Mode; Using The Aux Input; Auto Power Off - Panasonic SC-NA30 Operating Instructions Manual

Wireless speaker system
Hide thumbs Also See for SC-NA30:
Table of Contents

Advertisement

Using LP mode

This mode minimises power consumption of the battery by lowering the speaker
output. (
8)
Press and hold [LP] for 2 seconds or more until the LP mode indicator
(green) lights up.
The LP mode is enabled.
• Press and hold [LP] for 2 seconds or more again will return the setting back to the normal mode.
Note
• Even when the AC adaptor is connected, LP mode remains enabled.
• In LP mode, even when the volume knob is adjusted, the volume of the unit may not increase.
• Turning off the LP mode may cause the volume to jump up suddenly. Before turning off the LP
mode, lower the volume.

Using the AUX input

You can listen to audio via the AUX IN jack (
a device with an audio cable (commercially-available).
Note
• When using the AUX input, AUX input has priority than the Bluetooth
features.
(It will be possible to receive a call hands-free by pressing [
in on the device connected with Bluetooth
• The setting of the Bluetooth
is inserted into AUX IN jack.
• When using the AUX input, the volume may seem low depending on the connected device. In
that case, check if the volume limit can be changed on the device. For details, refer to the
manual of the device.
• If an audio cable (commercially-available) is inserted during audio playback with a Bluetooth
connection, noise may occur. In this case, stop the playback on the device connected via
Bluetooth
.
®

Auto Power Off

This unit automatically turns off if there is no audio input and no operation is
performed for approximately 10 minutes.
Note
• If the AUX IN jack is in use while the AC adaptor is connected, this function will not work.
• This function may operate even when the music is being played back if the volume of the
connected device is low.
• This function may not operate depending on the connected device.
• When the DC OUT terminal is in use, this function will not work.
[NA30]
• The Auto Power Off function is activated, the retractable panel will remain lowered when the unit
is turned off. To leave the retractable panel raised when the unit is turned off, press [Í/I] twice.
.
14)
®
is not changed even if the audio cable (commercially-available)
®
6, 7) when this unit is connected to
features and NFC
®
] when there is a call coming
®
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc-na10

Table of Contents