Flying Yoke Use - EM Acoustics EMS-121X User Manual

Attachment of the FC-121v vertical flying cradle
Using the supplied M10 hexagon head bolts, align the mounting holes
in the mounting bars with the mounting points on the sides of the
enclosure. Ensure that both the flat and spring washers are used –
the flat washer should be in contact with the cradle. Tighten the bolts
to ensure a solid fit. Once the desired angle of the loudspeaker is set,
tighten the knobs on the cradle to lock the position in place. The
bracket allows for complete rotation of the loudspeaker if required.
The points on the top of the flying cradle can be used for permanent
installations or to secure a hook clamp. Ensure that an M10 eyebolt is
secured to a rear or top point on the EMS-121X enclosure to use as a
secondary safety.
Attachment of the FC-121h horizontal flying cradle
Using the supplied M10 hexagon head bolts, align the
mounting holes in the end mounts of the yoke with the
mounting points on the top and the bottom of the
enclosure. Ensure that both the flat and spring washers
are used – the flat washer should be in contact with the
cradle. Tighten the bolts to ensure a solid fit. Once the
desired angle of the loudspeaker is set, tighten the knobs
on the cradle to lock the position in place. The bracket
allows for complete rotation of the loudspeaker if required.
The points on the top of the flying cradle can be used for
permanent installations or to secure a hook clamp. Ensure
that an M10 eyebolt is secured to a rear point on the EMS-
121X enclosure to use as a secondary safety.
Assembly of clusters using the DFB-121 flyplate set
Using the supplied M10 hexagon head bolts, bolt through the DFB-121
plate into the enclosure. Ensure that both the flat and spring washers
are used – the flat washer should be in contact with the plate. Once the
desired angles of the loudspeakers are set, tighten the bolts to lock in
place. Then turn the cluster over and repeat the process on the bottom.
Use the rear points on the EMS-121X enclosures, or the M10 holes on
the DFB plates to use as a secondary safety.
9
EMS-121X User Manual
www.emacoustics.co.uk