INTRODUCTION Thank you Thank you for purchasing a product from the acclaimed EMS Series from EM Acoustics. The EMS Series products have been carefully designed and rigorously tested to ensure years of flawless operation and unprecedented sonic quality. Flexibility is the key factor with EMS products, and consequently they are at home within a wide variety of applications from live and portable applications, through to cafes, bars, nightclubs, theatres and conference centres.
Due to its discreet size and appearance, the EMS-122/122w can be used in a wide variety of applications ranging from corporate and theatre use, to medium scale front of house and floor monitoring duty.
Loudspeaker systems are potentially dangerous objects if used incorrectly. Please ensure that you read this section fully, and contact EM Acoustics or your local dealer should you be in any doubt over correct operation procedures. Professional loudspeaker systems are capable of producing damage-inducing sound pressure levels, and hence care should be taken when setting your system up, particularly when it comes to loudspeaker placement within a venue.
Should you be in any doubt whatsoever, please contact your local dealer who will be able to refer you to a suitable rigging company. Cabling and Amplifier Selection The EMS-122 and EMS-122w are designed to be used with professional power amplifiers providing the following power outputs: EMS-122/EMS-122w...
– we would stress that the higher the filter, the safer the loudspeaker will be. If you are in any doubt over suitable settings for your EMS-122, please don’t hesitate to contact EM Acoustics or your local dealer for support and advice.
These fixings allow suspension in any orientation, with the extra point on the rear of the enclosure available for pull-back to obtain the desired rigging angle or as a secondary safety point. The EMS-122 also has four M8 threaded fixings on the rear for use with Omnimount Series 60 or Powerdrive Series 100 installation mounting hardware.
Ensure that an M8 eyebolt is secured to the rear point on the EMS-122 enclosure to use as a secondary safety. Attachment of the FC-122h horizontal flying cradle...
For larger down-tilt angles, position the pivot on the last hole and use the point on the rear or underside as a pull-back. Ensure that an M8 eyebolt is secured to the rear point on the EMS-122 enclosure to use as a secondary safety. Assembly of clusters using the DFB-122 flyplate set Using the supplied M10 socket head bolts, bolt through the DFB-122 plate into the enclosures.
MAINTENANCE Your EM Acoustics loudspeakers have been rigorously tested before they leave our factory, to ensure that they give you a lifetime of flawless operation. Should any of your drive units fail and need replacing, please follow the guidelines below.
Serial numbers must be quoted in all correspondence relating to the claim. EM Acoustics or its representatives are in no way liable for any loss or damage in transit, and hence it is recommended that the sender insure the shipment.
APPENDIX A – TECHNICAL SPECIFICATIONS EM Acoustics operates a continuous process of research and development, and as such reserves the right to alter specifications without notice. EMS-122/EMS-122w ENCLOSURE TYPE: two-way passive, reflex loaded DIMENSIONS (HxWxD): 622 (24.5) x 380 (15) x 364 (14.3) mm/(ins) NET/SHIPPING WEIGHT: 27/29kg (59.4/63.8lbs)