INTRODUCTION Thank you Thank you for purchasing the acclaimed M-10 stage monitor from EM Acoustics. The M-10 has been carefully designed and rigorously tested to ensure years of flawless operation and unprecedented sonic quality. Acoustics Monitors are designed to provide a smooth and coherent frequency and phase response, while having enough SPL capability where required –...
The M-10 has been designed with the lowest profile possible for maximum discretion on stage. As with all EM Acoustics full-range products, no active controller or programmed EQ is required for correct operation.
Loudspeaker systems are potentially dangerous objects if used incorrectly. Please ensure that you read this section fully, and contact EM Acoustics or your local dealer should you be in any doubt over correct operation procedures. Professional loudspeaker systems are capable of producing damage-inducing sound pressure levels, and hence care should be taken when setting your system up, particularly when it comes to loudspeaker placement within a venue.
STAGE ORIENTATION The HF unit in an M-10 is on the left-hand side as you look at the monitor. This is easily denoted as the badge in the grille sits over the 10” drive unit on the right. When arranging on stage, the position of an M-10 relative to other monitors on stage will affect the sound.
MAINTENANCE Your EM Acoustics loudspeakers have been rigorously tested before they leave our factory, to ensure that they give you a lifetime of flawless operation. Should any of your drive units fail and need replacing, please follow the guidelines below.
Serial numbers must be quoted in all correspondence relating to the claim. EM Acoustics or its representatives are in no way liable for any loss or damage in transit, and hence it is recommended that the sender insure the shipment.
APPENDIX A – TECHNICAL SPECIFICATIONS EM Acoustics operates a continuous process of research and development, and as such reserves the right to alter specifications without notice. M-10 Enclosure Type: 2-way passive, reflex loaded Dimensions (HxWxD, mm/ins): 297/11.7 x 560/22 x 400/15.7 Net Weight: 17kg (37.4lbs)