Delay Spin; Default Temp - Dexter Laundry T-300 VENDED Operator's Manual

3. "Delay Spin" is meant to be used in applications where the amount of drain
capacity is limited. In these cases the washer cannot empty the tub in sufficient
time to allow for a spin cycle to occur.
When a time value (other than 0) is programmed for the "Delay Spin" option, the
end of each bath will be extended by the selected time. Therefore, extra time will
be allowed for the drain valve to be open and compensate for slow drain
capacity. The factory default setting is 0 seconds.
4. "Default Temp" allows the user to choose which water temperature ("Hot",
"Warm", or "Cold") will be active during Idle mode. The customer can, of course,
choose other temperatures for the wash bath based on other options described
in this manual.
The figure below shows the sub menu options for Cycles:
8514-223-001 REV B page 15