remove shipping materials and Parts included for Before you start... parts from inside the microwave Installation: oven. Locate templates and set them aside to be used later. The installation hardware items make sure the microwave oven Your safety and the safety of are in a small bag.
Product dimensions 14-1/16" 1-1/8" to 23-7/8" 15-9/16" bottom of utensil bar Location NOTE: This microwave oven is intended for installation over a countertop. Do not install this microwave oven above any heat source such as a range or cooktop. there must be at least one wall stud within cabinet opening...
Electrical requirements You must have: WARNING 3-prong 120-volt, 60Hz, AC-only, 15 or 20 ground plug amp, fused electrical supply. outlet located in the upper cabinet as close as possible to the microwave hood. We recommend: a time-delay fuse or circuit Electrical Shock Hazard power ground...
Page 5
toggle IMPORTANT: This oven cannot be bolt Using the carton may properly installed without make installation easier. To use referring to the mounting carton: instructions found on wall and upper cabinet templates. mounting plate Insert toggle bolts into plate. Follow instructions on the Start toggle nuts on toggle bolts.
Page 6
power cord Installing the top cabinet screw hanger and flat washer Screw power cord hanger Utensil Bar into convienient location inside cabinet. Make a bundle of the NOTE: None, one or both of the power supply cord and attach it utensil bars may be installed.