Alpine CDE-135EBT Owner's Manual page 40

 Rear USB Connector (CDE-135EBT only)
Connect this to a USB Memory or to an iPod/iPhone. To use an iPod/
iPhone, Interface cable for iPod connection is required.
Notes
• Use the supplied USB cable. If a USB cable other than the supplied is
used, correct performance cannot be guaranteed.
• Route the USB cable away from other cables.
 Antenna Receptacle
 Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if
applicable.
Note
• This lead should be used only for controlling the vehicle's power
antenna. Do not use this lead to turn on an amplifier, or a signal
processor, etc.
 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier.
 Not used
 Illumination Lead (Orange)
This lead may be connected to the vehicle's instrument cluster
illumination lead. This will allow the backlighting of the CDE-135EBT/
CDE-134EBT to dim whenever the vehicle's lights are turned on.
 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse box or
another unused power source which provides (+)12V only when the
ignition is turned on or in the accessory position.
 Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's battery.
 Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure
the connection is made to bare metal and is securely fastened using
the sheet metal screw provided.
 Right Front (+) Speaker Output Lead (Grey)
 Right Front (–) Speaker Output Lead (Grey/Black)
 Right Rear (–) Speaker Output Lead (Violet/Black)
 Right Rear (+) Speaker Output Lead (Violet)
 Left Rear (+) Speaker Output Lead (Green)
 Left Rear (–) Speaker Output Lead (Green/Black)
 Left Front (–) Speaker Output Lead (White/Black)
 Left Front (+) Speaker Output Lead (White)
 Fuse Holder (10A)
 MIC Input Connector
To Microphone.
 Steering Remote Control Interface Connector
To steering remote control interface box. For details, contact your
Alpine dealer.
 Front Output RCA Connectors
RED is right and WHITE is left.
 Rear Output RCA Connectors
RED is right and WHITE is left.
 Subwoofer Output RCA Connectors
RED is right and WHITE is left.
 Power Supply Connector
 Microphone (Supplied)
 RCA Extension Cable (sold separately)
 Front AUX Input Terminal
This terminal allows for input of audio from an external device (such
as a portable player), using a commercially-available converter cable.
38
-EN
 Front USB Terminal
Connect this to USB Memory or to an iPod/iPhone.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the
car harness.
• Keep the battery power leads as far away from other leads as
possible.
• Connect the ground lead securely to a bare metal spot (remove
any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away
from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention
measures so consult your dealer for further information.