Table of Contents
Advertisement
10.2.
ATST Command
The ATST command, will return the following information:
STATISTICS
Good RX Packets
With Bad CRCs
With Bad Noise
Bytes received
Bytes transmitted:
Packets send
ACKs received
ACKs transmitted :
Pkts last minute :
UART errors
OK
If there is a hardware problem, there may be one ore more hardware error
messages listing the error types (CPU Exceptions, OS Rebooted, or
Fatal OS failures). Consult the factory if any of these messages ever
appear.)
10.3.
ATST1 Command (GPS Statistics)
The ATST 1 command, will return various information regarding the operation of the GPS features
in the ATLAS PL.
M7 PL Technical Manual
(packets received over the air with no bit-errors and correct address)
:
nnn
(over-the-air packets with bit errors that were discarded)
:
nnn
(receptions that were aborted due to noise, CW jamming, lost signal...)
:
nnn
(number of bytes this modem received, and sent out its serial port)
:
nnn
(number of bytes this modem received via the serial port, and transmitted
nnn
over the air)
(number of packets this modem has transmitted over the air.
:
nnn
Retransmissions in the ARQ mode are not counted)
(Number of ACK packets this modem received, when ARQ was enabled)
:
nnn
(Number of ACK packets sent over-the-air in the ARQ mode)
nnn
(Number of packets received during the last minute)
nnn
(serial port framing and overrun errors. Usually these are caused by
:
nnn
incorrect serial port settings)
36
Raveon Technologies Corp.
Advertisement
Table of Contents
