Table of Contents
Advertisement
Format
$GPWPL
$PRAVE
$GPTLL
$GPGGA
$GPGSV
6.6.
Device Addressing
Security Key
The security KEY programmed into every ATLAS PL transponder ensures that only
ATLAS PL transponders with the exact same security code can receive position
and status information. The security key is case sensitive, so "Raveon" and
"RAVEON" are two different keys.
The security code may be from 2 to 16 characters long. The longer the code, the
more secure it is and the less likely anyone could guess what it is. It is up to the
user to select and set this code. If the ATLAS PL is not used in a system where
security and privacy are a concern, then it is OK to leave the factory-set code.
If it is important that the ATLAS PL transmissions and system be secure, Raveon
suggest you program the KEY to be a random sequence of letters and numbers at
least 8 digits long.
When you program your own security code into your ATLAS PL transponders, write
it down in a secure place. This parameter cannot be read out of the ATLAS PL. If
you forget what it is set to, you will have to reset all the security codes in all of your
ATLAS PL Transponders.
M7 PL Technical Manual
NMEA WayPoint List.
share waypoint locations among GPS units. The ATLAS PL
can output this message when it receives a position report
from other ATLAS PL transponders. A GPS connected to it,
should put a waypoint on its screen, and in its database, at
the location specified by the RV-M7.
Raveon Position & Satus.
ATLAS PL when it is operating in the GPS 2 mode. This
message is used by third-party and PC applications for
tracking location and status information.
NMEA Target Lat Long.
by marine RADAR receivers to notify plotting devices of the
location of a RADAR target. The ATLAS PL can output this
message when it receives a position report from other
ATLAS PL transponders. A plotter or display connected to it
that supports the TLL message, should put an icon on its
screen at the location specified by the RV-M7. The icon
name is the MYID of the RV-M7 that transmitted its position
over the air.
NMEA GPS Position Fix Data.
standard position message from a GPS receiver.
NMEA Satellites in view.
message to indicate the number of satellites in view, and
their signal quality.
30
This message is commonly used to
This message is sent out of the
This message is commonly sent
This message is the
This message is the standard
Raveon Technologies Corp.
Parameter/setting
OUTPUT 3
OUTPUT 1
OUTPUT 2
NMEAOUT 1
NMEAOUT 1
Advertisement
Table of Contents
